Dip Switch Configuration Chart - Belkin OmniView ENTERPRISE Quad-Bus Série Manuel De L'utilisateur

P74290ea_F1DExxxC_man.qxd 30-10-2003
INSTALLATION

DIP Switch Configuration Chart

N° DU COMMUTATEUR DIP
1 2 3
BAS BAS BAS
HAUT BAS BAS
BAS HAUT BAS
HAUT HAUT BAS
BAS BAS HAUT
HAUT BAS HAUT
BAS HAUT HAUT
HAUT HAUT HAUT
BAS BAS BAS
HAUT BAS BAS
BAS HAUT BAS
HAUT HAUT BAS
BAS BAS HAUT
HAUT BAS HAUT
BAS HAUT HAUT
HAUT HAUT HAUT
Example:
Four OmniView ENTERPRISE Quad-Bus Series KVM Switches (F1DE208C) are
daisy-chained together to control 32 computers. The DIP switch on the primary units
are set to "BANK Address 00" and the secondary units are each set to a unique BANK
address between 01 and 15 (BANK 00 needs to be configured for daisy-chain operation,
as noted above).
Installation
Before you begin:
1. Make sure that all computers and switches are powered off and that each Switch
has been assigned a unique BANK address.
2. Place primary and secondary Switches in the desired locations.
11:20 Page 14
ADRESSE BANK
4
BANK 00 (valeur par défaut)
BAS
BAS BANK 01 PRIMAIRE/SECONDAIRE
BAS BANK 02 SECONDAIRE
BAS BANK 03 SECONDAIRE
BAS BANK 04 SECONDAIRE
BAS BANK 05 SECONDAIRE
BAS BANK 06 SECONDAIRE
BAS BANK 07 SECONDAIRE
HAUT BANK 08 SECONDAIRE
HAUT BANK 09 SECONDAIRE
HAUT BANK 10 SECONDAIRE
HAUT BANK 11 SECONDAIRE
HAUT BANK 12 SECONDAIRE
HAUT BANK 13 SECONDAIRE
HAUT BANK 14 SECONDAIRE
HAUT BANK 15 SECONDAIRE
14
INSTALLATION
3. Connect the console monitor, keyboard, and mouse to the console ports of the primary
Switch(es), as previously described for standalone units, skipping steps 5 and 6.*
Hosts 1 & 2 Hosts 3 & 4 Hosts 5 & 6 Hosts 7 & 8
*Dual-console support available on 2x8 and 2x16 models only.
4. Connect the computers to the Switch as previously described for standalone Switches.
Hosts 1 & 2 Hosts 3 & 4
Hosts 1 & 2 Hosts 3 & 4
15
Hosts 1 & 2 Hosts 3 & 4 Hosts 5 & 6 Hosts 7 & 8
Hosts 5 & 6 Hosts 7 & 8
Hosts 5 & 6 Hosts 7 & 8