Kenwood SW-18HT Mode D'emploi page 3

Connections
Note on connection
1. Be sure to turn off your amplifier before connecting or
disconnecting speaker.
2. This speaker system has a nominal impedance of 8
ohms. To drive this speaker satisfactorily and safely, use
an amplifier which can be connected to the speaker
having a load impedance of 8 ohms.
÷ Never short-circuit the + and - speaker cords.
1
2
Twist wire's
Push
conductor
(–)
CENTER
FRONT
R L C
RED WHITE GREEN
SPEAKERS (8-16Ω)
Speaker terminals (Receiver)
Right Left
Note on operation
The power-handling capacity of this speaker system is
indicated in the specifications. Do not operate the
speaker with power exceeding this limitation, as it may
damage the speaker.
3
4
Insert the
Release
conductor
Wire with
white line
Purple (+)
SUB
SURROUND
WOOFER
R L SW
GRAY BLUE PURPLE
Specifications
Type ................................................................... Subwoofer
Enclosure ......................................................... Bass-Reflex
Loudspeaker .......................... 160 mm (6-1/2 ") Cone type
Nominal Impedance ....................................................... 8 Ω
Peak Input Power ....................................................... 120 W
Maximum Input Power ................................................ 80 W
Nominal Input Power ................................................... 40 W
Sensitivity ..................................................... 83 dB / at 1 m
Frequency Response ................................... 40 Hz ~ 700 Hz
Dimensions ............................. Width: 175 mm (6-7/8 ")
Net Weight .................................................... 5.2 kg (11.5 lb)
Accessories
Speaker cord (Purple) .................................................. 1
Cushion ......................................................................... 4
NOTE: THE GRILLE CANNOT BE REMOVED.
Note:
KENWOOD follows a policy of continuous advancements in
development. For this reason specifications may be changed
without notice.
Attaching the cushions
Attach four cushions to the base of the subwoofer, one
at each corner. The cushions prevent the subwoofer from
sliding, and dampen its vibrations.
Height: 400 mm (15-3/4 ")
Depth: 306 mm (12-1/16 ")
3
EN