Installation Of The Fin; Deflation - Gong CHIP Série Guide De L'utilisateur

INSTALLATION OF THE FIN

INSTALLATION OF THE FIN
1 - Slide the Nut inside the US Box towards the front of the Board.
2 - Place the Base of the Fin in the rail of the Box and
slide the Fin to the position of your choice.

DEFLATION

1 - To deflate the Board, open the Valve cover and
press the button to turn it down to «deflate.» Do
not be surprised by the air that escapes from the
Valve. Do not deflate your board on the water.
EN
3 - Move the Nut so that it is facing the hole in the
base of the Fin, insert the screw, and tighten.
2 - Remove your Fin. Roll up your Board carefully
starting from the back of the Board, pad towards
the inside. Do not tighten too close to the Fin box
to avoid generating tension.
ANY QUESTIONS ? / Contact our Team
https://www.gong-galaxy.com/en/help-contact/
- 13
GONG-GALAXY.COM