Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tighten the nut on the plate.
Be careful not to catch the cluth and control cable
between handle an handle frame.
1.
HANDLE POSITION
2.
HANDLE LOCK GRIP
3.
PLATE
4.
HANDLE
5.
WIRE
6.
BOLT
2) CONNECTING CLUTH CABLE
Insert the clutch cable throught the slot of the cable bracket on the left handle.
Connect the clutch cable end to the clutch lever pin with push nut.
1.
PUSH NUT
2.
CLUTCH BAIL PIN
3.
CLUTCH CABLE
4.
CABLE BRACKET
3) INSTALLING SHIFT LEVER UPPER
Connect the extension shift lever to the shift lever using cotter pin.
Spread cotter pin to secure.
A. Wrong
B. Correct
1. SHIFT LEVER (UPPER)
2. SHIFT LEVER (LOWER)
3. COTTER PIN
4) WIRING
Fix harness and control wirest to the handle with wire band.
1. BANDE DE CABLES
2. HARNAIS (CABLE DE COMMANDE)
III - BEFORE STARTING ENGINE
NOTE : The engine is shipped without oil. Fill the engine to the proper oil level before starting. Be very
carefu not to allow dirt to enter the engine when checking or adding oil or fuel.
1) FILL THE ENGINE WITH OIL
(1) Put the plate with 4 to 5 cm thickness under the machine to keep engine horizontally.
(2) Remove the oil filler plug
(3) Fill with recommended engine oil up
Quantity of oil : 0,6 l
NOTE : Check the oil level before each use.
OIL FILLER AND GAUGE
Recommended oil ➔ 10W 30
Oil capacity 0,6 L
1
6
2
1
B
1
A
2
5
3
3
4
3
1
2
4
EN
2
5
Publicité
Table des Matières
