ResMed AirFit F20 Mode D'emploi page 14

CAUTION
• Visible criteria for product inspection: If any visible deterioration
of a system component is apparent (cracking, discolouration,
tears, etc.), the component should be discarded and replaced.
• The cushion must not be submerged in liquid as this may damage
the cushion and affect mask performance.
• Discard the cushion if it is submerged in liquid or heavily soiled.
Cleaning the cushion
You do not need to clean the cushion every day. If any visible
deterioration of the cushion is apparent, the cushion should be discarded
and replaced.
• If required, wipe the outside of the foam cushion with CPAP wipes or
similar alcohol-free wipes and allow to dry.
• Do not rinse or submerge in liquid
• Do not expose to domestic cleaning products or cleaning devices
• Do not store or place in direct sunlight.
Cleaning the frame and elbow
Daily:
1. Disassemble the mask components according to the disassembly
instructions.
2. Rinse the frame and elbow under running water.
3. Clean with a soft brush until dirt is removed.
4. Soak the components in warm water (approximately 30°C) with a mild
liquid detergent for up to ten minutes.
5. Shake the components vigorously in the water for at least one minute.
6. Brush the moving part of the elbow and around the vent holes.
7. Brush the areas of the frame where the arms connect, and inside and
outside the frame where the elbow connects.
8. Rinse the components under running water.
9. Leave the components to air dry out of direct sunlight. Make sure to
squeeze the arms of the frame to ensure excess water is removed.
8