What To Do If - IKEA HÖGVÄRDIG Mode D'emploi

ENGLISH
Removing the residues and stubborn
residues:
1. Food containing sugar, plastics, tin foil
residues should be removed at once,
best tool for cleaning glass surface is a
scraper (not included with the appli-
ance). Place a scraper on the glass ce-
ramic surface at an angle and remove
residues by sliding the blade over the

What to do if...

Problem
The appliance cannot be
switched on or is not operat-
ing.
Acoustic signal sounds, ap-
pliance switches off.
Display is switching between
two heat settings.
lights up on the heat set-
ting display.
symbol plus a number
appears on the heat setting
display.
2. Limescale rings, water rings, fat
Possible cause
More than 10 seconds have
passed since the appliance
was switched on.
The child safety device is
switched on .
Several sensor fields were
touched at the same time.
One or more sensor fields
have been covered for lon-
ger than 10 seconds.
Power management is re-
ducing the power of this
cooking zone.
Unsuitable cookware.
No cookware on the cook-
ing zone.
The diameter of the bottom
of the cookware is too small
for the cooking zone.
Electronics fault.
surface. Wipe the appliance with a
damp cloth and a little washing up liq-
uid. Finally, rub the appliance dry using
a clean cloth.
splashes, shiny metallic discolorations
should be removed after the appliance
has cooled down using cleaner for
glass ceramic or stainless steel.
Switch the appliance on
again.
Deactivate child safety de-
vice (See the section "Child
safety device" ).
Only touch one sensor field.
Uncover sensor field.
See the section "Switching
the power function on and
off".
Use suitable cookware.
Place cookware on the
cooking zone.
Move onto a smaller cook-
ing zone.
Disconnect the appliance
from the electrical supply for
a few minutes (Take the fuse
out of the house's electric
system) If after switching on
again,
again, call the after sales
service.
10
Remedy
is displayed