Checklist - Joyello JL-1050 SECURFIX BRUUM Mode D'emploi

GB
IMPORTANT! Make sure the indicator (U) on the support foot is green. If the indicator is red you
must readjust the support leg. To remove the car seat base from the vehicle simply open the belt
lock and remove the seat belt.
To remove the base of the child car seat from the car seat just open the red belt lock (H) to release
the car's safety belts after having disengage them from the buckle.

CHECKLIST

To ensure the optimum Safety of your child, check the following after installation:
Check that the seat belt is as tight as possible and not twisted!
Check that the diagonal and lap section of the vehicle belt pass under the red belt guides and
through the red belt lock (4) (5)!
Check that the support leg is fully extended to the floor and locked into position and the indicator
on the foot of the support leg is green (6).
Check that the car seat base is installed securely and firmly in the vehicle by trying to move it!
INSTALLING THE BASE-USING THE ISOFIX POINTS
WARNING! Always give preference to using the rear seats of your vehicle even if your highway code
permits the use on the from seat. check your highway code as this regulation may vary according to
the country. Check the vehicle manual for advice on fitting your car seat in the front of the vehicle.
WARNING! AIRBAGS CAN CAUSE INJURY. DO NOT USE THIS CHILD SEAT ON A PASSENGER
SEAT FITTED WITH A FRONTAL AIRBAG
Unfold the support leg and place the car seat base onto the vehicle seat (1).
Squeeze together the ISOFIX adjustment buttons (R) located on either side of the support leg at
the front of the seat base, and push the support leg towards the seat base to extend the ISOFIX
attachment points (6).
Line the ISOFIX attachment points with the ISOFIX connectors in the vehicle seat, and push the
ISOFIX points into the ISOFIX connectors until you hear a "click"(10).
When the ISOFIX points are correctly attached, the ISOFIX connection indicators (S) will turn green
(11) if the indicators remain red you must release and re-connect the ISOFIX points, to do this see
section "REMOVING THE BASE- when attached to the ISOFIX points".
Once the ISOFIX points are correctly attached, push the base towards the vehicle seat backrest until
firm (9).
IMPORTANT! Always use the support leg when the car seat base is fitted into the vehicle.
WARNING! Ensure that at all times the support leg is in contact with the floor of the vehicle and
the indicators are green.
To adjust the support leg, squeeze the support leg adjustment button (T) located on the back of the
support leg and move the foot of the support leg downwards until it reaches the vehicle floor (12).
IMPORTANT! Make sure that support leg indicator (U) is green. If the indicator is red you must
28