Getting To Know Your Appliance; The Control Panel; The Hotplates; Residual Heat Indicator - Junker JR36DT50 Mode D'emploi

Getting to know your appliance

The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2.
&RQWURO SDQHO IRU
– H[WHQGHG FRRNLQJ
# FKLOGSURRI ORFN
&RQWURO SDQHO IRU
Controls
When you touch a symbol, the respective function is activated.

The hotplates

Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
Extended cooking zone
æ
When the hotplate is activated: the corresponding indicator lights up.
When the hotplate is switched on: the last selected size is automatically selected again

Residual heat indicator

The hob has a two-stage residual heat indicator for each
hotplate.
If appears in the display the hob is still hot. It may be used,
•
for example, to keep a small meal warm or to melt cooking

Setting the hob

This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch on: touch the
#
indicator above the main switch lights up. The hob is ready for
use.
To switch off: touch the #
main switch goes out. All hotplates are switched off. The
residual heat indicator remains on until the hotplates have
cooled down sufficiently.
Note: The hob switches off automatically if all hotplates have
been switched off for more than 20 seconds.
20
]RQH
&RQWURO SDQHO IRU
PDLQ VZLWFK
KHDW VHWWLQJ DGMXVWPHQW
Activating and deactivating
Touch the
Touch the
symbol. A signal sounds. The
symbol until the display above the

The control panel

'LVSOD\V IRU
KHDW VHWWLQJ³É
UHVLGXDO KHDW ‡¤
RSHUDWLQJ UHDGLQHVV ¯
Í GXDOFLUFXLW KRWSODWH
© HOHFWURQLF ERLO VWDUW FRQWURO
Notes
The settings will remain unchanged if you touch several
■
symbols at once. This allows you to wipe up spills on the
control panel.
Always keep the controls dry. Moisture reduces their
■
effectiveness.
symbol
ð
symbol
æ
chocolate. As the hotplate cools down further, the display
changes to œ . The display remains lit until the hotplate has
cooled sufficiently.

Setting a hotplate

Use the + and - symbols to set the desired heat setting.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
There is an intermediate setting between each heat setting. This
is identified by a dot.
Setting a heat setting:
The hob must be switched on.
Touch the + or - symbol.
1.
lights up in the display.
‹
&RQWURO SDQHO IRU