Safety Regulations - Proxxon MICROMOT 50 E Mode D'emploi

PROXXON - MICROMOT 50 (E/EF)
GB
Dear customer,
Please read the enclosed safety regulations
and operating instructions carefully before
using the unit.

Safety regulations

Warning!
Read all instructions. Failure to follow all i
n structions listed below may result in electric
shock, fire and/or serious injury. The term
„power tool" in all of the warnings listed
below refers to your mains operated (corded)
power tool or battery operated (cordless)
power tool, also machines and electric units.
Only use the power tool for the purpose
for which it was intended, with the due
attention to the general safety and accident
prevention regulations.
SAVE THESE INSTRUCTIONS!
1.) Work area
a) Keep work area clean, tidy and well lit.
Cluttered and dark areas invite accidents.
b) Do not operate power tools in
explo sive atmospheres, such as in
the pre sence of flammable liquids,
gases or dust.
Power tools create sparks which may
ignite the dust or fumes.
c) Keep children and bystanders away
while operating a power tool.
Distractions can cause you to lose
control.
2.) Electrical safety
a) Power tool plugs must match the
outlet. Never modify the plug in any
way. Do not use any adapter plugs with
earthed (grounded) power tools.
- 8 -
Unmodified plugs and matching outlets
will reduce risk of electric shock.
b) Avoid body contact with earthed or
grounded surface such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of electric shock
if your body is earthed or grounded.
c) Do not expose power tools to rain or
wet conditions.
Water entering a power tool will increase
the risk of electric shock.
d) Do not abuse the cord. Never use the
cord for carrying, pulling or unplugging
the power tool. Keep cord away from
heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the
risk of electric shock.
e) When operating a power tool outdoors,
use an extension cord suitable for
outdoor use.
Use of a cord suitable for outdoor use
reduces the risk of electric shock.
3.) Personal safety
a) Stay alert, watch what you are
doing and use common sense when
operating a power tool. Do not use a
power tool while you are tired or under
the influence of drugs, alcohol or
medication.
A moment of inattention while operating
power tools may result in serious personal
injury.
b) Use safety equipment. Always wear eye
protection.
Safety equipment such as dust mask, non-
skid safety shoes, hard hat, or hearing
protection used for appropriate conditions
will reduce the risk of personal injuries.
c) Avoid accidental starting. Ensure the
switch is in the off position before
plugging in.
Carrying power tools with your finger on
the switch or plugging in power tools that
have the switch on invites accidents.
Never bridge the switch.