Dometic 972 Notice D'utilisation page 9

972, 976
NOTICE!
A
Never put the sanitary additive into the portable toilet when the
slide valve is closed
➤ Press the pump approx. 15 times or until air comes out the cap of the flush
water tank through the pressure relief valve (fig. 6, page 2).
NOTICE!
A
 Do not subject the flush water tank to too much pressure, for in-
stance by covering up the pressure relief valve.
 Do not pressurise the flush water tank if it is separated from the
holding tank.
6.2 Flushing the portable toilet
NOTE
I
Changes in the ambient temperature or the actual height above sea
level while travelling can cause the pressure in the holding tank to
rise or fall.
Before use, make sure that the pressure in the holding tank is
equalised by opening and closing the slide valve with the seat cov-
er closed.
➤ Pull out the flush grip to allow the waste to pass into the holding tank
(fig. 8, page 3).
➤ Press the flush button to flush the portable toilet (fig. 9, page 3).
➤ Push the flush grip to close the slide valve.
6.3 Emptying the holding tank
When the filling level display shows "Full", (fig. 0, page 3), the holding tank
needs to be emptied.
➤ Pull the locking grip on the holding tank if the toilet is fitted with the option-
al fastening holders. To reach the rear bracket, lift up the toilet and move
it.
➤ Pull up the rear latch to disconnect the flush water tank from the holding
tank (fig. a, page 3).
➤ Take the holding tank to a reliable disposal station (or a normal toilet).
EN
Operation
9