Functional Description; Intended Use; Product Features - Bosch GST 14,4 V Professional Notice Originale

OBJ_BUCH-624-003.book Page 19 Tuesday, October 20, 2009 11:37 AM
Use only sharp, flawless saw blades. Bent or
unsharp saw blades can break or cause kick-
back.
Do not brake the saw blade to a stop by ap-
plying side pressure after switching off. The
saw blade can be damaged, break or cause
kickback.
Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assistance.
Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line
causes property damage or may cause an
electric shock.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Do not open the battery. Danger of short-
circuiting.
Protect the battery against heat, e. g.,
against continuous intense sunlight,
fire, water, and moisture. Danger of
explosion.
Use only original Bosch batteries with the
voltage listed on the nameplate of your pow-
er tool. When using other batteries, e. g. imi-
tations, reconditioned batteries or other
brands, there is danger of injury as well as
property damage through exploding batteries.

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
Bosch Power Tools
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.

Intended Use

The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ce-
ramic plates and rubber while resting firmly on
the workpiece. It is suitable for straight and
curved cuts with mitre angles to 45°. The saw
blade recommendations are to be observed.

Product Features

The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Lock-off button for On/Off switch
2 On/Off switch
3 Battery*
4 Battery unlocking button
5 Base plate
6 Switch for sawdust blowing device
7 Adjusting lever for orbital action
8 SDS clamping lever for saw blade release
9 Stroke rod
10 Guide roller
11 Contact protector
12 Saw blade*
13 Handle (insulated gripping surface)
14 Splinter guard*
15 Sliding shoe
16 Screw
17 Lead for the parallel guide
18 Locking screw for parallel guide*
19 Parallel guide with circle cutter*
20 Centring tip of the parallel guide*
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
2 609 932 701 | (20.10.09)
English | 19