Film Loading And Threading - GBC HeatSeal H800 Pro-R Mode D'emploi

CUT-OFF BLADE
LAME DE COUPE
CUCHILLA DE CORTE
MAIN ON/OFF SWITCH
INTERRUPTEUR
PRINCIPAL
MARCHE/ARRÊT
INTERRUPTOR
PRINCIPAL ON
(ENCENDIDO)/OFF
(APAGADO)
Figure 6A
SAFETY SHIELD LATCH
VERROU D'ÉCRAN DE SÉCURITÉ
SUJETADOR DE SEGURIDAD
SAFETY SHIELD
ÉCRAN DE SÉCURITÉ
CUBIERTA DE SEGURIDAD
FEED TABLE LATCH
VERROU DU PLATEAU
D'ALIMENTATION
SUJETADOR DE LA
TABLA DE
ALIMENTACIÓN
Figure 6B
"J" CHANNEL
VOIE EN J
CANAL "J"
IDLER BAR
BARRE DE TRANSFERT
BARRA GUÍA
Figure 6C
8
CIRCUIT BREAKER
DISJONCTEUR
INTERRUPTOR AUTOMÁTICO DE
CIRCUITO
FEED TABLE
PLATEAU D'ALIMENTATION
TABLA DE ALIMENTACIÓN
OPERATING INSTRUCTIONS
CAUTION: Make sure safety shield and feed tray are in the
!
proper position to operate the unit.

FILM LOADING AND THREADING

It is recommended that loading and unloading film be performed
when the laminator is cool (room temperature).
Refer to Figure 6B and follow the procedures to remove the
Feed Table:
1. Remove the safety shield by sliding the latch, located on the
upper left side to the right, while lifting the shield up and away
from the laminator.
2. Slide the feed table latch to the right.
3. Lift the table upwards and away from the laminator.
If reloading film, cut remaining top and bottom film webs between
supply rolls and heat shoes. Be careful not to scratch the heat
shoes. Remove the old rolls and check the heat shoes for
adhesive residue. This can be easily removed by wiping with a
damp cloth. Do not use abrasives as they will damage the
Teflon coating on the heat shoe.
Change the top and bottom roll at the same time.
GBC laminating film is labeled near the end of each roll with
'Warning - End of Roll'. When this label appears on either
the top or bottom roll of film, a new roll of film must be installed
as soon as the item presently being laminated exits the laminator.
Use core adaptors from the previous roll.
Laminating film must unwind from the bottom of the roll
(dull side up). Shiny side of film should be against the
heat shoes.
Use the alignment guides on the film shaft to be certain that
the top and bottom rolls are aligned properly.
Slide lower idler bar slightly upward and toward the back
of laminator.
Unwind top and bottom film rolls enough to allow film slack
for threading (Figure 6C).
Thread film from upper supply roll under the idler bar and
drape film over heat shoes.
Thread film from lower supply roll around the lower idler bar
and drape over heat shoes.
Reposition the lower idler bar in the 'J' channel.
Position the feed tray and safety shield so that the
latches are engaged.