Battery Replacement; Replacement Procedure - Tripp-Lite SmartPro 2U Série Manuel Du Propriétaire

Battery Replacement

Under normal conditions, the original batteries in your UPS will last many years. See Safety section
before replacing batteries. The batteries are designed for hot-swap replacement (i.e. leaving the
UPS in ON mode), but some qualified service personnel may wish to put the UPS in the OFF mode
and disconnect equipment before proceeding. Note: Refer to the label on the battery retention
plate for the R.B.C. part number.
SMART3000RM2UP and SMART3000RMXL2U Battery (RBC58-2U)

Replacement Procedure

1
Remove Front Panel
1 4 x screws
2
Remove Battery Retention Plate
4 x screws
2
3
Disconnect Batteries
3
14-03-028-93-3088.indb 18
4
Remove/Recycle Batteries
First, remove the left row of batteries.
4A
Then, slide the right row of batteries to
4B
the left and remove.
4A
4B
18
3/20/2014 4:08:54 PM