Installation; Parent Unit; Baby Unit; Placement - Alecto DBX-10 Mode D'emploi

7.

INSTALLATION

Parent Unit:

Connect one of the included power adaptors with the DC5V connecti-
on to the left side of the parent unit and place the adapter into a 230V
electrical outlet. The parent unit is now ready for use.
Batteries are not included.
The parent unit comes with a belt clip. The belt clip allows you
to carry and use the baby unit hands free.

Baby unit:

Connect one of the included power adaptors with the DC5V connec-
tion located on the right side of the baby unit and place the adapter
into the 230V electrical power outlet.
The baby unit is now ready for use.
The baby unit does not have a battery operating function.

Placement:

Place the baby unit in the nursery room approximately 2 meters away from the
baby.
MAKE SURE THAT THE BABY CANNOT TOUCH THE ADAPTER
CORD. ALSO MAKE SURE THE BABY UNIT CANNOT FALL INTO THE
CRIB.
Do not place the baby unit or the parent unit in direct sunlight or in a damp place.
The baby monitor is not waterproof. Too much moisture may cause damage to the
electronics.
If you would like to use the parent unit cordless, slide
down the battery cover on the back of the parent unit
and place the 3 1,5V batteries (type: AAA) into the
parent unit.
You can use either normal or rechargeable batteries. The parent
unit does not have a battery charging function. Rechargeable
batteries need to be charged separately.
Bm1117
-18-
Bm1117
GB
Bm1117