Yamaha C-5000 Mode D'emploi page 7

D. TRIM selector
Switches the headphone amp gain. The unit will adjust
the volume level when headphones are plugged in to
avoid sudden changes in volume by modifying the level
balance between the audio output from the PHONES jack
and from the speakers.
Choices: −6 dB, 0 dB, +6 dB, +12 dB
E. GAIN selector
Switches the preamp gain. The unit will smoothly adapt to
the power amp gain and speaker sensitivity, enabling you
to make fine volume adjustments. For more information,
refer to "Adjusting the volume level" (page 30).
Choices: −12 dB, −6 dB, 0 dB
F. OUTPUT selector
Specifies which OUTPUT jacks will output signals, as
follows:
Use this selector if multiple power amplifiers are
connected.
OUTPUT selector
OFF ALL
BAL
— Output
jacks
LINE 1
— Output
jacks
LINE 2
— Output
jacks
G.
PHONO selector
Indicates the type of cartridge installed on the turntable
that is connected to the PHONO jacks on the rear panel
(MM, MC 300Ω, MC 100Ω, MC 30Ω, MC 10Ω). For
more information, refer to "Adjusting the turntable input
setting" (page 29).
NOTICE
Before you replace the cartridge, be sure to turn off the
power to this unit .
BAL LINE1 LINE2
Output — —
— Output —
— — Output
7