Auto Power Standby Switch - Yamaha C-5000 Mode D'emploi

µ ¸
Note
The volume level is fixed . Operating the VOLUME control or
GAIN selector on this unit will not change the volume level
of the signal from the EXT . IN jacks . Adjust the volume level
using the volume control on the component connected to
the EXT . IN jacks .
L. BAL jacks
These are XLR-type output jacks. Connect these jacks to
the balanced input jacks on the power amplifier.
M. LINE 1/LINE 2 jacks
These are RCA output jacks. Connect these jacks to the
RCA input jacks on the power amplifier.
N. TRIGGER IN/TRIGGER OUT jacks
These are monaural mini jacks. Connect external
components that support the trigger function here.
For more information, refer to "Trigger connections"
(page 24).
¹
O.
These are monaural mini jacks. Connect external
components that support the remote function here.
For more information, refer to "Remote connections"
(page 25).
P.
This jack is used to service the product. It is rarely used.
Q.
Specifies whether the unit automatically enters standby
mode.
ON: The unit enters standby mode automatically if it is
powered on but not operated for eight hours.
OFF: The unit does not enter standby mode automatically.
R.
Connect the supplied power cord here. For more
information, refer to "Connecting the power cord"
(page 26).
REMOTE IN/REMOTE OUT jacks
SERVICE jack

AUTO POWER STANDBY switch

AC IN jack
13