Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The washing machine is not
filling
The washing machine is not
draining or spinning
The washing machine is not
spinning
I cannot see any water in the
drum during washing
safety and troubleshooting
If F01 appears on the display: Check the water supply
is not cut off, the water tap is open and the washing
machine water entry filter is not blocked.
Solution: Wait until the water supply comes back on,
turn on the water supply tap, remove the water inlet
hose and clean the filter.
If this failure occurs, F01 will appear on the display.
If F02 appears on the display: Check that the pump or
the outlet pipe of the building are not blocked, and that
the pump is properly connected.
Solution: If the pump is blocked, follow the instructions
given in point 2 of Maintenance and Cleaning the
appliance. If this failure occurs, F02 will appear on the
display.
Cause: The clothes are badly distributed in the drum,
and there is a risk of excessive vibration.
Solution: Redistribute the clothes evenly and run a spin
dry programme.
If this failure occurs, C3 will appear on the display.
The washing machine is provided with an environment-
friendly system able to adapt to the load and type of fabrics,
adjusting the levels of water and energy used. So, although
the water level you can see through the door may look
low, there is no cause for concern as washing and rinsing
efficiency will still be optimum.
22
Publicité
Table des Matières
