Installation - Electrical Connection; Maintenance / Disposal; Environmental Protection - PROLUMIA LED Pro-Line Retrofit Manuel D'utilisation

INSTALLATION - ELECTRICAL CONNECTION

Luminaire connection:
L1 Luminaire connection (standard)
L2
L3
N
PE
DALI + (optional)
DALI - (optional)
Power setting via DIP switches (not available for DALI version).
The power can be adjusted as described below.
Phase change:
1. Disconnect the lead wire (brown) of the LED driver from the supply connector (male connector, WAGO 267-510) at terminal position 1.
2. Connect the lead wire (brown) of the LED driver to the power supply plug (male connector, WAGO 267-510) at free terminal positions
(terminal position 2, terminal position 3), depending on the outer conductor required.
WARNING!
Dangerous voltages! Installation and maintenance must only be carried out by qualified personnel!

MAINTENANCE / DISPOSAL

1. Before carrying out any maintenance work, make sure that the power has been switched off.
2. Use water, possibly in combination with an environmentally friendly detergent, to clean the cover and housing of
the lamp. Please do not use caustic cleaning detergents.
3. Clean the cover regularly to maintain a high luminous flux.
4. Do not use a high-pressure cleaner for cleaning.

ENVIRONMENTAL PROTECTION

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.
Brown
Grey
Black
Blue
Yellow-Green
Red
White
www.prolumia.eu
11