Scope Of Delivery - PROLUMIA LED Pro-Line Retrofit Manuel D'utilisation

BLIND PIECE
Art. no. Beam angle / measurements
4064038 / x x
0: Blind piece, 20°, 7 core cable, 1525mm
1: Blind piece, 60°, 7 core cable, 1525mm
2: Blind piece, 90°, 7 core cable, 1525mm
3: Blind piece, 20°, 7 core cable, 300mm
4: Blind piece, 60°, 7 core cable, 300mm
5: Blind piece, 90°, 7 core cable, 300mm
ACCESSORIES
Art. no. Accessories
40640390 Male 7 core cable connector for connecting the first fixture
40640391 Male + Female 7 core cable connector - set
40640392 Wiring harness 7 cable core with male / female connector 1565mm

SCOPE OF DELIVERY

Please check the goods carefully for completeness.
Contents:
1x Pro-Line Retrofit
1x Instruction manual
INSTALLATION - GENERAL NOTES
1. Assembly, installation and maintenance may only be carried out by a qualified electrician.
2. During installation, the instructions in this manual must be followed.
3. Before the initial installation and each replacement of the luminaire, it must be ensured that the power supply is switched off.
4. The electrical connection must be made properly in accordance with all applicable standards and directives.
5. The luminaire may only be operated within the specified voltage range.
6. Operation and storage must take place within the nominal temperature range.
7. Never repair the lamp yourself. The repair may only be carried out by the manufacturer.
8. The lamp must not be used if the housing is damaged or broken. Broken protective covers must be replaced immediately. If you notice any damage
to the lamp, contact your local dealer.
9. Before installation, the load-bearing capacity of the ceiling and the fastening elements must be ensured.
10. Products that are suspended from the ceiling must be secured with a safety rope or similar.
11. Keep the luminaire away from heat and vibration sources and avoid any contact with corrosive chemicals.
12. The distance between the luminaire and a radio should be at least one metre in order to avoid possible interference with radio reception.
13. The luminaire must not be covered or wrapped with insulating material. Since the maximum working temperature around the luminaire can cause
temperatures of 70°C, a distance of 75mm must also be maintained between the luminaire and heat-insulating materials and building parts (ceiling
mounting is excluded).
14. Please take care to comply with the corresponding IP class when connecting the luminaire.
15. Disassembly and assembly of add-on parts must only be carried out when the power is off.
8
www.prolumia.eu