Prepare The Receiver Collar; To Insert And Remove The Batteries - Radio Systems PetSafe Guardian Underground Fence Guide D'emploi

Collier récepteur
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Prepare the Receiver Collar

Your Receiver Collar comes with short Contact
Points installed. Use the long Contact Points for
pets with long or thick hair. Tighten the Contact
Points with the Test Light Tool one-half turn
beyond finger tight (A). Check the tightness
weekly. Before inserting the batteries, wipe the
outer edge of the battery door with a clean cloth
to remove any dirt or debris.

To Insert and Remove the Batteries

1. Turn the battery door counter-
clockwise using the edge of the
Test Light Tool as shown (B).
2. Install two (2), 3-volt batteries
positive (+) side out, negative
(-) side pointed toward inside of
battery unit (C). Place the lower
3 Volt battery under the positive
battery contact. Insert the upper
3 Volt battery against the positive
battery contact (D).
3. Replace the battery door using
the edge of the Test Light Tool
as shown. Turn the battery door
clockwise (E).
Battery life will vary depending on how often your pet tests the
system and receives a Static Correction. Check the Receiver Collar
every month to ensure the batteries are working properly.
B
D
www.guardianpet.net
A
C
E
3

Publicité

Table des Matières
loading

Table des Matières