Short Loop Test - Radio Systems PetSafe Guardian Underground Fence Guide D'emploi

Short Loop Test

The Short Loop Test is a simple test to determine if each component (Fence
Transmitter, Receiver Collar and Boundary Wire) is functioning properly.
1. Disconnect the Boundary Wire.
2. Cut approximately 10 feet of unused Boundary Wire and connect it to
the Boundary Wire Terminals.
3. Spread the Boundary Wire out into a circle.
4. Set the Boundary Width Control knob to 10.
5. If the Loop Indicator Light is not lit, then your Fence Transmitter is not
functioning properly. Contact the Customer Care Center at
1-866-381-2785 (US) / 1-800-457-3911 (Canada).
6. If the Loop Indicator Light is lit, disconnect one end of the Boundary
Wire from the Boundary Wire Terminal.
7. If the Loop Indicator Light does not go out, the Fence Transmitter needs
to be replaced. Contact the Customer Care Center at 1-866-381-2785
(US) / 1-800-457-3911 (Canada).
8. If the Loop Indicator Light goes out, plug the Boundary Wire back into
the Boundary Wire Terminal.
9. Hold the Test Light Contacts to the Receiver Contact Points. Hold
the Receiver Collar next to the 10-foot length of Boundary Wire. The
Receiver Collar should beep about one foot away from the Boundary
Wire. The Test Light should then fl ash as you hold the Receiver Collar
closer to the Boundary Wire.
10. If Receiver Collar does not beep and the Test Light does not fl ash,
replace the batteries in the Receiver Collar. If it still does not beep and
the Test Light does not fl ash, contact the Customer Care Center at
1-866-381-2785 (US) / 1-800-457-3911 (Canada).
11. If the Receiver Collar beeps, there may be a complete or partial break in
the Boundary Wire.
www.guardianpet.net 13