babymoov Babyphone Expert Care Notice D'utilisation page 10

Receiver
Press the latch cover and slide it to gain access to
the battery compartment. Remove the battery.
Proceed as for the transmitter to set the channel and
numeric code.
Make sure that the settings for the transmitter and
receiver are exactly the same.
NB.: If you notice any interference when in operation, change channel or alter the numeric code combination.
Make sure that you always keep the same settings for the transmitter and receiver.
Transmitter
1. Nightlight
2. Microphone sensitivity adjustment
3. Transmit indicator
4. Microphone
5. Nightlight VOX control button
6. Power On-Off and Nightlight switch
7. Power on / Battery low indicator
8. DC Jack
Charger
16. Charging pins
17. DC Jack
18. Charging Indicator
A / Transmitter
• Set the power ON/OFF switch (6) to ON position to turn on the unit. The power on indicator (7) will light
up steady green.
• Place the transmitter about 1 m from the cradle, directing the microphone (4) towards the baby.
• Adjust the sensitivity of the microphone by using button (2): press upwards to increase sensitivity and
downwards to reduce it (there are 5 levels).
• As soon as the transmitter detects a sound, the transmit indicator lights up red.
• The night light (1) can be set permanently ON by moving the power ON/OFF switch (6) to position
The night light can also be set to be VOX (voice activated) by momentarily pressing the button 5. Under
VOX mode, the night light will be switched on once the microphone detects a sound and automatically
goes off a few seconds after the microphone stops picking up any sound.
• The condition of the batteries is shown by the battery low indicator "Power" (7). When the battery power
is being consumed, the indicator starts flashing.
B / Reveiver
• Set the power ON/OFF switch (14) to ON position to turn on the unit. The power on indicator (7) will light
up steady green.
• Place the receiver at a reasonable distance away from the transmitter to avoid feedback. Too close a
distance will create a screeching sound.
• Once the unit receives a signal from the transmitter, the LED of the visual level meter (9) light up. The
louder the baby's voice, the more number of LED will be lighted up.
• The loudspeaker volume can be adjusted by using buttons (10) and (13). Each time you press on one of
these buttons, you will hear a "beep" whose volume corresponds to the level you have just selected. If
you press button 10 to its lowest level, you will no longer hear a beep which means that your receiver is
in mute mode.
10
CONTROLS LAYOUT
OPERATION
BABY MONITOR EXPERT CARE • Instruction Manual
Receiver
9. Visual level meter / Out-of-range indicator
10. Volume down
11. Vibration indicator
12. Speaker
13. Volume up
14. Power On/Off and vibration switch
15. Charging contacts
Transmitter and receiver
19. Channel switch
20. Digital codes switches
.