Charging / Discharging Pb Batteries - GRAUPNER SJ ULTRA DUO PLUS 80 Instructions D'utilisation

Maximum capacity MAX. CAPACITY
If you enter a value for maximum capacity, then the charge process is automatically halted when this capacity is reached. The default setting is 120%.
The effective life of the battery can be increased by reducing this value.
SAFETY TIMER
The safety timer halts the charge process after the set time. The adjustment range is OFF to 300 minutes, the factory default setting is 120 minutes.

Hold the ENTER button
pressed in for 2 sec. to
start the charge process
11] Pb 6S 60000mAh

CHG. : 7.0 A 2.3V/C
DCHG. : 5.0A 1.8V/C
ENTER
0 ] NiMH 6S 3300mAh

CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
C-CV-CC : 0:00:12
CAPACITY : 10mAh
Mode
VOLTAGE : 12.612V
CURRENT : 2.80A
0 ] NiMH 6S 3300mAh

CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
ESC
DCHG. : 5.0A 0.8V/C
52

18. Charging / discharging Pb batteries

[ Pb ] CHARGE
*** BATTERY ***
*** CHECK ***
0 ] NiMH 6S 3300mAh

CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
C-CV-CC : 0:01:25
INPUT VOLT : 14.222V
Mode
PEAK VOLT : 12.612V
AVG. VOLT : 0.000V
0 ] NiMH 6S 3300mAh

CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
ESC
DCHG. : 5.0A 0.8V/C
ESC
END
CHARGE
Before starting a process please ensure that all parameters
are set correctly to match your battery type, and that the
battery is connected correctly to the charge output. Use the
INC or DEC button to move the Select arrow to the approp-
riate line: Charge (CHG) or Discharge (DCHG). With a brief
press on the ENTER button you can run through all the pa-
rameters of the selected mode once more, and adjust them
if necessary. Start the process by holding the ENTER button
pressed in for two seconds.
If you wish to alter the charge current during the charge pro-
cess, press the ENTER button briefly: the charge current
is highlighted, and can be adjusted using the INC or DEC
C-CV-CC : 0:02:59
BAT. TEMP. : 22.1°C
button.
PEAK TEMP. : 22.1°C
BATTERY RES: 30mΩ
0 ] NiMH 6S 3300mAh Pressing the MODE or ESC button switches between the

CYCLE : C->D 1x 10m
various charge displays. If you wish to halt the charge pro-
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
cess, hold the ESC button pressed in for two seconds.
Hold the ENTER
button pressed in
for 2 sec. to stop
the charge process

Operating Manual ULTRA DUO PLUS 80