Publicité
Les langues disponibles
Les langues disponibles
7.-
FITTING THE MONITOR.-
Take hold of the monitor (C) and bring it up to main
post (B) Fig.10, connect the terminals (5PIN; 2PIN;
4PIN) Fig.10A, coming out of the bottom of the monitor,
with terminals (B1; B3; B4; B5) Fig.10A coming up out
of the top of the main post (B), Fig.10.
Attach the monitor (C) using screws (C1), Fig.10,
making sure not to pinch the wires.
8.-
FITTING THE UPPER FOCUS BARS.-
Remove the bolts (J8) and the nuts (J9) from the upper
arm (H1) Fig.11A.
Take the upper arm (H1) (marked with the letter L) and
insert it into the connector tube for the arm (G1) Fig.11,
aligning the bolt holes.
Fit the bolts (J8) along with the nuts (J9) Fig.11B and
tighten securely with the help of the two spanners.
Go through the same procedure for the upper right
focus bar (H2) (marked with the letter R).
IMPORTANT: It is advisable to retighten these
screws after one month of using the machine.
LEVELLING.-
Once the unit has been placed into its final position,
make sure that it sits flat on the floor and that it is level.
This can be achieved by screwing the adjustable feet
(E4) up or down, as shown in Fig.12.
LOCKING ARM & FOOT MOVEMENT. -
This exercise machine incorporates a system for
locking the footrests and focus bars to help get on the
machine safely and to protect children.
To lock footrest and focus bar movement, before
dismounting the exercise machine turn the knob (A3)
Fig.13, (clockwise), making sure that the two footrests
are always centred to help get on and off the machine.
To unlock footrest and focus bar movement, turn the
knob (A3) Fig.13, anticlockwise.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (F5), as shown in
Fig.14, which make it easier to move.
The two wheels at the front of the unit make it easier to
place the unit in to any chosen position by lifting the
rear slightly.
Store your unit in a dry place, preferably not subject to
changes in temperature.
MAINS CONNECTION.-
Plug the cable into a 220 V mains supply, Fig.15.
LENGTH OF STEP ADJUSTMENT.-
This exercise machine has a variable length of step
adjustment between 18" (450mm) and 26" (660mm).
To adjust this setting, select the stride on the display
at the bottom of the monitor, Fig.16.
If lock, you will hear a "beep" and will not change
stride. Unplug the machine, wait 30 seconds and
reconnect the machine.
Do not hesitate to get touch with the Technical
Assistance Service if you have any queries by phoning
customer services (see last page in manual)
BH RESERVES THE RIGHT TO MODIFY THE
SPECIFICATIONS OF ITS PRODUCTS WITHOUT
PRIOR NOTICE.
16
G820
Publicité
