Ryobi CCG-1801 Manuel D'utilisation page 5

GB
FR DE ES
SPECIFICATIONS
Voltage
No load speed
- High
- Low
BATTERY PACK
MODEL
(not included)
BPL-1820
BPL-1815
BATTERY PACK
(not included)
CCG-1801
BPP-1815
BPP-1815M
BPP-1817
BPP-1817M
DESCRIPTION
1. Caulk Gun
2. Plunger Rod
3. Puncture Tool
4. Carriage Frame
5. Switch Trigger
6. Switch Lock
7. Variable Selector
8. Plunger Rod Handle
9. Battery Pack (Not included)
10. Latches
11. Spout
12. Caulk Tube (Not included)
OPERATION
WARNING
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating tools. Failure
to do so could result in objects being thrown into
your eyes, resulting in possible serious injury.
IT NL PT DK SE
18 V
5.5 mm/s
1 mm/s
CHARGER
(not included)
BCL-1800
BCS618
BCL1418
CHARGER
(not included)
BCL-1800
BCS618
BCL1418
BC-1815S
BC-1800
FI NO RU PL CZ
English
WARNING
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal
injury.
APPLICATIONS
You may use this tool for the following purposes:
Sealing cracks to keep your home's conditioned
■
air inside while keeping unconditioned air outside,
increasing your home's energy efficiency.
Filling holes and cracks before painting.
■
Creating a moisture barrier around areas that could
■
be damaged by water.
Sealing cracks to keep insects from crawling inside
■
your home.
Applying adhesive.
■
TO INSTALL BATTERY PACK (NOT INCLUDED)
(Fig. 2)
Lock the switch trigger by sliding the switch lock up.
■
Place the battery pack on the tool.
■
Make sure the latches on each side of the battery
■
pack snap into place and the battery pack is secured
on the tool before beginning operation.
CAUTION
When placing battery pack in the tool, be sure
raised rib on battery pack aligns with the bottom
of the drill and latches into place properly.
Improper installation of the battery pack can
cause damage to internal components.
TO REMOVE BATTERY PACK (NOT INCLUDED)
(Fig. 2)
Lock the switch trigger by sliding the switch lock up.
■
Depress the latches on the side of battery pack.
■
Remove the battery pack from the tool.
■
BATTERY PROTECTION FEATURES
Ryobi 18 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life. Under some operating conditions, these
built-in features may cause the battery and the tool it is
powering to act differently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to
stop running. To reset the battery and tool, release the
trigger and resume normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
1
HU RO LV LT EE HR SI SK GR TR