Craftsman CMXECXM331 Guide D'utilisation page 10

ENGLISH
Fig. D
10
7. After the water has been drained, close the drain valve.
NOTE: If drain valve is plugged, release all air pressure. The
valve can then be removed, cleaned, and reinstalled.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
Repairs
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a CRAFTSMAN
factory service center or a CRAFTSMAN authorized
WARNING: Risk of Unsafe Operation. Unit cycles
automatically when power is on. When servicing,
you may be exposed to voltage sources, compressed
air, or moving parts. Before servicing unit unplug or
disconnect electrical supply to the air compressor,
bleed tank of pressure, and allow the air compressor
8
ENGLISH
Storage
Before you store the air compressor, make sure you do
1. Review the Maintenance section on the preceding
pages and perform scheduled maintenance
2. Drain water from air tank. See To Drain Tank
Maintenance.
WARNING: Risk of Bursting. Water will condense
in the air tank. If not drained, water will corrode
and weaken the air tank causing a risk of air
3. Protect the electrical cord and air hose from damage
(such as being stepped on or run over). Wind air hose
and electrical cord loosely around compressor handle.
4.
8