Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SETTING THE CHAIN COUNTER - SYSTEM ERRORS
EN
SW VERSION
VERSIONE SW
VX . X
SET DEFAULT
ARE YOU SURE?
YES
NO
CHECK FLASH
CHECK FLASH
TRUE:
XXXX
SUM:
YYYY
CHECK EEPROM
CHECK EEPROM
TRUE:
XXXX
SUM:
YYYY
CAN MESSAGE
TX MSG:
000
RX MSG:
000
LAST ID:
000
CAN UPD:
000
CAN CONFIG
SET VALUE:
MASTER
SLAVE
SYSTEM ERRORS
System errors may arise when the chain counter is turned on.
Checksum error
The following windows are displayed if the counter detects an error in the memorized data:
CONTROL CHECKSUM
FLASH CHECKSUM
ERROR
TRUE:
XXXX
SUM:
YYYY
If one of these messages appears do not use the chain counter and contact a service center or QUICK® customer service
without delay.
MULTI MASTER
ERRORE
SET VALUE:
MASTER
SLAVE
32
SETTINGS MENU - UTILITY - SW VERSION
This function displays the software version installed in the chain counter.
SETTINGS MENU - UTILITY - SET DEFAULT
This function allows the user to enter the default values and restart the chain counter.
YES or NO can be entered.
SETTINGS MENU - UTILITY - CHECK FLASH (program memory)
This function shows the calculated FLASH memory checksum (SUM) and the one stored
during production (TRUE).
In order for the chain counter to operate properly the two values must match.
SETTINGS MENU - UTILITY - CONTROL EEPROM (data memory)
This function shows the calculated EEPROM memory checksum (SUM) and the one
stored (TRUE).
In order for the chain counter to operate properly the two values must match.
SETTINGS MENU - UTILITY - CAN MESSAGE
This function shows some information regarding CAN messages transmission state.
SETTINGS MENU - CAN CONFIGURATION
This option allows the user to determine chain counter's priority in the CAN network
(see chapter MULTIPLE CHAIN COUNTERS).
MASTER and SLAVE can be entered (default: MASTER).
FLASH memory
checksum error
Multi Master error
If the chain counter detects more then one of MASTER chain counters in the CAN net-
work, the following window is displayed:
Select chain counter's priority in the CAN network
(see chapter MULTIPLE CHAIN COUNTERS).
CONTROL EEPROM
EEPROM CHECKSUM
ERROR
TRUE:
XXXX
SUM:
YYYY
EEPROM memory
checksum error
CHC1203 IT EN FR - REV001A
Publicité
Table des Matières
