A
B
D
30
20
1. Press the release button (B) to open the
lid (C).
2. Put the detergent, in powder or tablets,
in the compartment (A).
3. If the programme has a prewash phase,
put a small quantity of detergent in the
compartment (D).
4. Close the lid. Make sure that the release
button locks into position.
Using the multi-tablets
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and
the rinse aid dispenser.
1. Adjust the water softener to the lowest
level.
2. Set the rinse aid dispenser to the lowest
position.
Setting and starting a
programme
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in programme selection mode.
3. Press the programme button repeatedly
until the indicator of the programme you
want to select comes on.
4. Close the appliance door to start the
programme.
C
Starting a programme with
delay start
1. Set a programme.
2. Press Delay to delay the start of the
programme of 3 hours.
• The indicator
3. Close the appliance door to start the
countdown.
When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
If you open the door while a programme is
running, the appliance stops. When you
close the door, the appliance continues
from the point of interruption.
Cancelling the delay start
Press and hold the programme button until
the appliance is in programme selection
mode.
When you cancel the delay start, you have
to set the programme again.
Cancelling the programme
Press and hold the programme button until
the appliance is in programme selection
mode.
Make sure that there is detergent in the
detergent dispenser before you start a new
programme.
End of the programme
When the programme is completed the
indicator
is on.
1. Press the on/off button to deactivate
the appliance.
2. Close the water tap.
If you do not deactivate the
appliance within 5 minutes all
indicators goes off. This helps to
decrease energy consumption.
11
comes on.