Rs232 Connector; Rotel Link ]; Dts Play-Fi R; Play-Fi Connection - Rotel T14 Manuel De L'utilisateur

English

RS232 Connector

[
The T14 can be controlled via RS232 for integration with automation systems.
The RS232 input accepts a standard straight DB-9 Male-to-Female cable.
For additional information on the connections, software, and operating
codes for RS232 control of the T14, contact your authorized Rotel dealer.
Rotel Link
]
See Figure 4.
The 2 ROTEL LINK OUT connectors can be used to connect to any Rotel
product with a ROTEL LINK IN connection, using the stereo 3.5mm cables
supplied.
This allows the attached Rotel products to communicate with each other and
be controlled via the Rotel App (available for download on the iTunes
NOTE: Only the Rotel Link cables supplied with this product should be
used. These 3.5 mm cables have WHITE connector ends and should
not be confused with the 12 Volt Trigger cables that have BLACK
connector ends.
®
DTS Play-Fi
The T14 includes the DTS Play-Fi wireless streaming ecosystem to effortlessly
stream HiFi grade audio from network attached storage devices and
multiple Internet based audio streaming services. For more information
on supported Play-Fi services please visit the DTS Play-Fi website at
https://www.play-fi.com.

Play-Fi Connection

To utilize the Play-Fi enabled services you will need to do the following:
Connecting T14
Ensure the Wi-Fi antennas have been installed and power on the T14 unit.
The Wi-Fi LED on the T14 rear panel will blink quickly on and off, every
0.5 seconds for 20 seconds. After which it should change to pulsing slowly
on and off, glowing from bright to dim and then bright again. This means
the T14 is ready to connect to your Wi-Fi network.
From your devices (phones, tablets, computers), download the free Play-Fi
App from an App store, such as the Google Play store, Amazon app
marketplace, or Apple App store. After download, launch and run the
Play-Fi App on your devices, following the relevant steps below, dependent
on your device type:
For the iOS devices:
1. Go to the SETTINGS menu on your iOS device.
2. Select the Wi-Fi settings menu and ensure Wi-Fi is enabled.
3. Wait for up to 90 seconds for the list of available Wi-Fi networks to be
refreshed and find the T14 enabled Play-Fi device listed at the bottom of
the list under the "SET UP NEW AIRPLAY SPEAKER" option.
＜
Settings
Wi-Fi
√
Network
CHOOSE A NETWORK
Network
Other...
SET UP NEW AIRPLAY SPEAKER...
Play-Fi Device
Ask to Join Networks
® store).
Known networks will be joined automatically. If no known
networks are available, you will have to manually select a
network.
4. Select the new Play-Fi device and confirm to add to the current Wi-Fi
network by choosing the desired Network listed and selecting Next.
Cancel
This AirPlay speaker will be set up to join "Network".
NETWORK
Network
Show Other Network
Speaker Name Play-Fi Device
SPEAKER PASSWORD
Password Optional
Verify Verify Password
NOTE: You can also rename the Play-Fi device by changing the Speaker
Name at this menu.
5. Wait for 60-90 seconds for the Play-Fi device to configure the settings
and attach to the wireless network. When connected, the rear panel
LED will stop flashing and be solid blue, the front display will indicate
"Connected".
Play-Fi
Connected
6. Launch the Play-Fi App to confirm if any software updates are needed
and select the desired audio source.
7. You're connected! From here, feel free to enjoy music.
10:17 AM 32%
Wi-Fi
i
i
＞
10:17 AM 32%
AirPlay Setup Next
√
11