Cleaning The Pre Motor Filters; Cleaning The Exhaust Filter - Hoover Vision Reach Manuel D'utilisation

EMPTYing THE Bin
1 To remove the bin from the cleaner press the
bin release button.
Hold the container over
2
the Bin and press the easy
open button.
The bin door will open and
you can empty into a bin
with no dust contact.
Once emptied, gently tap
4 3
or shake the container to
release any excess dust
from the filters.
Do not overfill the bin
above the max level line.

CLEaning THE PrE MOTOr FiLTErS

1
Rotate the upper part of the dust bin to open.
Remove the mesh frame from the filter,
3
then gently tap both filters to release
any excess dust.
!
iMPOrTanT! Ensure the mesh frame is
reassembled to the filter before use.

CLEaning THE EXHaUST FiLTEr

The exhaust filter should be washed every month. Press
down on the latch to remove the exhaust grille. Remove
filter and wash with warm water.
Remove excess water by shaking and leave to dry for 24
hours. Refit filters only when completely dry.
- 6 -
2
Remove the filter assembly from the bin top by
rotating the filter. It is advisable to wash the filters
after every 5 bin empties.
4 Wash both filter and protective mesh under warm
water until the water runs clean. Remove excess
water by shaking and leave to dry for 24 hours.
Reassemble and refit filters to cleaner, only when
they are completely dry.
gB