Cleaning The Filters; Your Guarantee - Hoover TELIOS EXTRA Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 7
REMEMBER: The bag check indicator also turns red (D or H2, H3)** if an obstruction
has occurred. In this case refer to 'Remove a Blockage from the System'.
Cleaning the Filters
To ensure constant optimum performances from your cleaner, please wash the
filters after each 5 bag changes.
Cleaning the pre-motor filter:
1.
Lift the bag door release latch to open bag door and remove the bag. [16,17]
Remove the pre-motor filter frame from the cleaner. [19]
2.
Remove the filter from the pre-motor filter frame. [19]
3.
4.
Wash the pre-motor filter and the pre-motor filter frame using hand warm water, and
allow it to dry thoroughly before inserting into the cleaner. [22,23]
Cleaning the exhaust filter
1.
Remove the exhaust filter, unclip the exhaust filter cover and remove the exhaust
filter pack. [20,21]
2.
Wash the exhaust filter pack in hand warm water, and allow it to dry thoroughly
before inserting into the cleaner. [22,20]
Remember: Do not use hot water or detergents. In the unlikely event of the filters
becoming damaged, fit a Genuine Hoover replacement. Do not try and use the product
without a dust bag or filters fitted.
Cleaning the permanent cloth dust bag* (*Certain model only)
To maintain optimum performance we recommended that you wash the permanent cloth
dust bag after every 5 full bags. Empty the contents of the bag into a bin, wash the bag
under warm water, remove excess water and leave to dry fully before replacing.
Removing a blockage from the system
If the bag check indicator remains lit (D or H1,H2)**:
1. Check if the bag is full. If so refer to 'Replacing the Dust Bag'.
2. If it is not full, then:
A. Do the filters need cleaning? If so refer to 'Cleaning the Filter'.
B. Check if there is any other blockage in the system.
-
Use a cord or a stick to remove any blockage from the telescopic tube or flexible hose.
Warning - The bag check indicator will remain red*or lit* if the cleaner is used when
the bag is full, if there is a blockage or if the filters are dirty. If the cleaner is used for
a significant period of time with the bag check indicator illuminated, an thermal cut
out will switch the cleaner off to prevent overheating. The bag check indicator turns
off once the cleaner has switched off to signal that the thermal cut out has been
activated. If this should happen, switch the cleaner off, unplug and correct the fault.
It will take about 30 minutes for the cut out to automatically reset.
Replacing the battery of the handle remote control*
If the remote controls on the handle do not respond when pressing any buttons,
please change the battery:
1.
Use screw driver to release remote control from handle.
2.
Remove the exhaust battery by pushing aside the clip and replace with a new one.
Use only battery type Lithium CR2032 3V.
USER CHECKLIST
Should you have a problem with the product, complete this simple user checklist before
calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another
electrical appliance.
• Is the dust bag over-filled? Please refer to 'Cleaner Maintenance'.
• Is the Filter blocked? Please refer to 'Cleaning the filter'.
• Is the hose or nozzle blocked? Please refer to 'Removing a blockage from the system'.
• Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically
reset.
• Doesn't the remote control on the handle respond? Please refer to 'Replace the
battery of handle remote handle'.
IMPORTANT INFORMATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model
number.
Hoover Service
Should you require service at any time, please contact your local Hoover Service Office.
Quality
Hoover's factories have been independently assessed for quality. Our products are made
using a quality system which meets the requirements of ISO 9001.

Your Guarantee

The guarantee conditions for this appliance are as defined by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
Subject to change without notice.
4
GB
[24]

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tx62alg 011

Table des Matières