Connection Diagram - Numark MIXTRACK PLATINUM Guide D'utilisation

User Guide (English)
Introduction
Box Contents
Mixtrack Platinum
USB Cable
Software Download Card
Support
For the latest information about this product (system requirements, compatibility information, etc.)
and product registration, visit numark.com.
For additional product support, visit numark.com/support.
Setup
1. Place Mixtrack Platinum on a flat, stable surface.
2. Make sure all devices are turned off and all faders and gain knobs are set to "zero".
3. If using a microphone, connect it to Mixtrack Platinum's microphone input.
4. Connect Mixtrack Platinum's outputs to power amplifiers, tape decks, and/or other audio
sources.
5. Plug all devices into AC power and connect Mixtrack Platinum's USB port to a computer's USB
port using the included USB cable.
6. When powering everything on, power on your devices in the following order:
• (1) Your computer, (2) any amplifiers, speakers, or output devices
7. Locate the Serato DJ Intro installation card in the box to download and install the software.
8. Open your software program and load music to the decks.
9. Start DJ'ing!
10. When powering everything off, power off your devices in the following order:
• (1) Any amplifiers, speakers, or output devices, (2) your computer

Connection Diagram

Computer
Headphones
Items not listed under
2
Introduction > Box Contents
User Guide
Safety & Warranty Manual
are sold separately.
Speakers
Microphone