Bresser Biorit ICD-CS Mode D'emploi page 6

To work with this microscope, sharp and pointed aids are being used.
Please take care that this microscope and its accessories are stored at a
place out of reach of children. Let children only work with this microscope
Keep packing material (plastic bags etc.) away from children!
1. Parts of the microscope
B
Eyepieces
C
Diopter adjustment ring
D
Illuminator
E
cable holder ring (a/b)
F
Vertical microscope arm
G
Base
H
Power switch
Suitable location for observation:
Dry and dust free, room temperature between -5 and +40°C.
Position your device so that it can be disconnected from the power supply at any time. The wall
socket should always be located near the device and be easily accessible, since the plug on the
power cord serves as a disconnecting device for the power supply.
2. Assembly
I. Place the base (6) on a stable surface.
II. Place the first cable holder ring on the horizontal microscope arm.
III. Place the second cable holder ring on the vertical microscope head pole.
IV. Fix both arms together, using the handle (8) with the spring lock washer.
V. Push the illuminator (3) through the hole opening in the microscope head.
3. Observation
Turn on the microscope using the power switch (7).
Now, look through the eyepieces (1) of the binocular viewing and change the spacing between
the eyepieces so that you get a round, clear field of view. The definition is adjusted by slowly
turning the focusing wheel (9).
If you have to observe a very large or very small object, you can adjust the microscope. Loosen
the holding screw on the side and move appropriately the microscope head on its guidance.
If you have found the correct position (distance of 22 cm from the object), tighten the holding
screw again.
6
CAUTION!
under an adult's supervision!
I
J
1)
O
O
O
D
Panhandle
Focusing wheel
Objective
A
Eyepieces,
B
2 Rubber eyecups,
C Replacement lamp