BORETTI BARISTA Notice D'emploi page 37

The installation procedure must be performed
in accordance with the local electrical and
safety regulations of the country where the
machine is being used.
The correct placement and installation proce-
dure for the machine is described below (see
fig. 1):
Remove the cup-tray (01) or hold it by the ed-
ges and slide it forward until you can get to the
top opening of the internal water tank below
(17).
Fill up the water tank with (approximately) 3
liters of drinking water and place the included
water filter into the tank.
After 5 minutes connect the thin hose to the
water filter. Make sure to connect the hose
while the filter is still inside the tray with water
in order to prevent it from emptying.
Place the cup-tray back to its original position.
Set the main switch (13) to the "ON" position
and verify that the built-in pilot light is lit, thus
indicating that the machine's electrical circuits
are being supplied with power.
You will hear the boiler being filled and
heated automatically. Wait until the boiler's
manometer (15) indicates 1.2 bar (approx.
after 15 min.).
Open the steam valve (16) for a few seconds
and then close it again.
Wait until the correct working pressure has
been attained again; the machine is now ready
for use.
ALARMS
If the internal water tank remains empty, all of
the machine's functions will be automatically
blocked by the Electronic Control Unit (ECU) in
order to prevent damage to the heating ele-
ment. This will be indicated by flashing LED
warning lights (02) located on the touch-pad
(04).
If this occurs you must first turn the machine
off. Subsequently control whether the water
tank is filled.
If the tank is filled it is possible that there is still
too much air in the water filter. Disconnect the
filter and immerse the filter into the water tank
again for 5 minutes. Then reconnect the filter
as described above.
To reset normal working conditions, turn the
main switch (13) to "OFF" first, then repeat the
procedure described above.
IMPORTANT NOTICE!!!
All refill and cleaning procedures must be car-
ried out with the machine disconnected from
the power outlet.
The manufacturer accepts no liability for injury
and damage to persons or property caused by
incorrect installation and/or use of the machine.
NL
FR
EN
37