Installation - BORETTI BARISTA Notice D'emploi

Installation

Installation Warning
PLEASE READ CAREFULLY
The manufacturer has tried too foresee all
possible safety provisions to ensure the safety
of the users. However, different installation
or equipment relocation conditions can cause
situations which cannot be controlled or fore-
seen. Therefore, it is absolutely necessary to
evaluate all remaining risks and to heed the fol-
lowing suggestions:
1. This machine is safe only if appropriately
connected to an efficient grounding sy-
stem complying with the applicable safety
standards in the country where the ma-
chine will be installed. The manufacturer
assumes no liability for accidents due to
non-compliance with the above-mentioned
standards, since incorrect installation
may result in injury to persons and animals
as well as damage to property. This appli-
ance must always be directly connected to
the power supply and the use of extension
cords or loose connections is strictly for-
bidden.
2. Do not leave packing items such as plastic
bags, Styrofoam, nails, etc. lying around,
because children or other people could get
hurt. All defects and discrepancies must
be immediately reported to the persons
authorized for installation and maintenan-
ce of the machine.
3. If the power supply cord is damaged it
must be replaced immediately and solely
by service staff qualified or authorized by
the manufacturer in order to prevent dan-
ger to people, animals and property.
36
4. Check the integrity of all components and
do not install defective or damaged parts.
Ask for replacement of any defective or
damaged parts.
5. Check and verify that the power outlet
supply voltage is the same shown on the
rating-plate of the appliance. This is loca-
ted underneath the removable catch ba-
sin.
6. The customer has to protect the power
outlet used for the machine by means of
a safety switch system (against over-
load) that complies with the applicable
standards and laws.
7. Installation of the included water softener
is mandatory. If the softener is not used
the warranty will become void.
8. The machine may not be placed in the di-
rect vicinity of a heat source such as an
oven or hot plate.
9. When installing the machine, a multipolar
main switch that has contacts with inter-
vals equivalent to or greater than 3 mm
should be connected, as stipulated by the
safety standards. Any unreliable cable
connection is not permitted.
10. The machine must be placed on a flat and
stable surface, leaving a minimum clea-
rance of 30 mm from walls.
11. The machine may only be used in combina-
tion with the included water filter.
Placement and Connection
Remove the machine from its packaging, fill up
the internal water tank and connect the ma-
chine to an appropriate power outlet through
the power supply cord.