BoomToneDJ Motion Beam Bar Mode D'emploi page 14

4- Menu
Display
DMX address
Channel mode
Slave mode
Auto Run mode
Sound mode
Sound Sense
Back light
PAN inverse
Tilt inverse
Auto Test
Fixture Time
Firmware Version
Reset
A. By Master/Slave built-in program function.
By linking the units in master/slave connection, the first unit will control the other units
to give an automatic, sound activated, synchronized light show. This function is good
when you want an instant show. You have to set the first unit in Automatic, sound
activated mode. Its DMX input jack will have nothing plugged into it. The other units will
have to select SL1 or SL2 , Their DMX cables plugged into the DMX input jacks (daisy
chain) and the slave led lights will constantly on.
B. By universal DMX controller
Using universal DMX controller to control the units, you have to set DMX address from 1
to 512 channel so that the units can receive DMX signal.
Press the MENU, then find Addr, press ENTER, when the 1 is showing on the display.
Pressing ENTER. Use DOWN and UP button change the DMX512 address.
6 channels DMX Protocole :
Value
1-512
6, 16, 28, 32
Master
SL 1
SL 2
Auto 0-16
Speed 1-9
0-16
0-100
ON/OFF
PAN1
PAN2
Tilt123 inverse
Tilt456 inverse
Enter
Enter
Enter
Enter
Description
Choose DMX add.
Nbr of DMX channels
DMX
Auto mode in master
Slave mode 1
Slave mode 2
Show 0-16
Speed 1-9
Sound shows 0-16
Mic. Sensitivity
Light screen
PAN1 inversion
PAN2 inversion
Tilt inversion 123
Tilt inversion 456
Test
14