Diagrams; General Safety Requirements; General; General Instructions - SMT SL20 Notice Technique

S M T

1.2 Diagrams

2 tapped holes, M5

2. GENERAL SAFETY REQUIREMENTS

2.1 General

All users must comply fully with all national or local laws, rules or regulations in force.
Anyone using this product must be thoroughly familiar with these instructions and other applicable
product instructions and manuals.
WARNING
!
instruction label. Failure to follow any instruction or warning within this instruction manual or on any
product label may result in a serious accident involving either personal injury, property damage or both.

2.2 General instructions:

•
Never carry out any maintenance or repair work on equipment which is under pressure (risk of
equipment being projected).
•
Maintain the sealing of the system.
•
Do not handle with tools; only manual handling is authorized.
•
Do not lubricate equipment or its accessories (risk of explosion).
•
Open the cylinder valve slowly (adiabatic compression, hammering phenomenon).
•
Do not smoke near the pressure regulator (risk of explosion).
•
Do not heat the pressure regulator or bring a naked flame anywhere near it (risk of explosion,
deterioration of the equipment).
•
Never supply the pressure regulator with a reverse flow (i.e. through the outlet): this could
contaminate or damage the equipment
•
Only use equipment which is in perfect condition.
•
Maintain the sealing of the systems.
•
Never move a cylinder on which a valve is installed, other than on a trolley.
•
Keep this equipment perfectly clean. The ingress of particles during the various handling operations is
the cause of most failures.
•
Ensure that the vent holes and the valve are not blocked
reserves the possibility at any time to change technical contents without previous consent
INSTRUCTION MANUAL
SL20 / SI20 PRESSURE REGULATOR
This is a pressure regulator designed for use in a pure gas installation. The
final manufacturer is responsible for preparing appropriate and adequate
instructions and warnings for the ultimate product user. The maintenance
instructions outlined below shall be incorporated into any product manual or
SMT - 5, rue de Labergement - BP10 - F-21110 GENLIS
L.P. pressure
Fixing ring (optional)
Hand wheel
NT 0009GB
Révision : 10
18/05/16
Page 14 / 32