Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Recirculation (option)
If you have chosen for recirculation, please follow
the instructions below.
Cleaning indication:
--------------------------------------------------------
Indication: red LED lights up
--------------------------------------------------------
The red LED will light up after 200 working hours
(time to regenerate the Monoblock recirculation
filter). The recirculation filter is to be found behind
the grease filter.
Remove the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• The Monoblock recirculation filter is found in
its opening in the cooker hood. Remove it from
the cooker hood.
Regenerate the Monoblock recirculation filter:
• The Monoblock can be regenerated up to 12
times. This is done in the oven.
• Place the filter in the oven for 1 hour at 120°C.
Provide sufficient fresh air in the room where
the oven has been placed, as smells can be
released. Smells can be released when baking
certain kinds of fish. In this case it is best to im-
mediately regenerate the filter in the oven.
Reset the Monoblock recirculation filter:
The cooker hood (motor) must be running!
Simultaneously press + and – for 5 sec. until
the red indicator lamp flashes 3 times for
confirmation. If the programming is not carried
out, the programming is automatically set after
the chimney hood has been switched on 10 times.
Place the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• Place the Monoblock recirculation filter is its
opening in the cooker hood.
• Put back the aluminium grease filter and close
the bottom plate.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood. Use a soft, wet
cloth and a mild detergent to clean the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel. The
stainless steel surfaces can be treated with Novy
Inoxcleaner (906.060) after cleaning.
780-C Gebruik NL-FR-DE-EN.indd 17
Replacement of the fluorescent lighting
Replacement of the led ligths
In the event of a malfunction, you can contact
your (kitchen) supplier and/or the Novy Customer
Service Department. In order for the Customer
Service Department to reply quickly and precisely
you must to tell them which type of extraction
hood you have. The model number can be found
on a sticker on the interior of the extraction hood.
This is visible as soon as you take the filter out
of the extraction hood. You can write down the
model number here:
Model number: ............................
Electrical connection
Electrical output: electrical cord + plug with
ground. To be plugged into socket with ground.
Check for compatibility with information on type
plate (behind filter).
Socket must be within reach.
Changes or replacement of the electrical cord
should be performed by a professional only.
Dimensions: p. 18
Electrical scheme: p. 19-20
EN 17
15/09/15 17:34
Publicité
Table des Matières
