Electrical Connection - Novy 7640/15 Mode D'emploi Et D'installation

B. Next, remove the LED to be replaced by
making a gentle rotating movement to the left.
3. Mounting the new LED:
A. Place the new LED light into the locking ring.
B. Make a rotating movement to the right until
the LED light is locked.
C. Connect the power cable.
D. Put back the cover and tighten the screws.
Then close the bottom plate.

Electrical connection

Electrical output: electrical cord + plug with
ground. To be plugged into socket with ground.
Check for compatibility with information on type
plate (behind filter).
Socket must be within reach.
Changes or replacement of the electrical cord
should be performed by a professional only.
Dimensions: p. 18
Electrical scheme: p. 19/20
EN 17