RACCORDEMENT HYDRAULIQUE / WATER CONNECTIONS / AANSLUITING WATERLEIDINGEN
- En outre, il ne faut absolument pas qu'en cas de sur-
pression, l'écoulement en résultant puisse être freiné.
Ceci implique que le tube de vidange ait une pente
continue et suffisante, et un diamètre adapté au débit.
2 - en écoulement libre, pour alimenter un seul point
d'eau : Ce type d'installation est spécialement adapté
aux chauffe-eau de la gamme des petites capacités de
10, 15, 30 et 50 L, sur-évier et sous-évier suivant les
modèles, lorsqu'ils ne peuvent être installés sous pres-
sion. L'installation doit être réalisée avec un robinet
mélangeur spécifique. Dans ce cas, il n'y a pas lieu
d'utiliser un groupe de sécurité.
Attention, il est normal que cela goutte par la
robinetterie, lors des périodes de chauffe. Ne pas
obstruer l'écoulement.
- Furthermore, if there is an overpressure, the resulting
flow must never be hindered. This means that the
drain pipe should have a continuous and sufficient
slope, and its diameter should be appropriate for the
flow.
During heating periods, the water contained in the
tank expands and some will escape as a slow stream by
draining (about 3% of the capaci+ty for each heating
cycle). This is nothing to worry about, this phenome-
non is absolutely normal.
It is recommended that a retention tank should be pla-
ced under the water heater with drainage if the tank is
installed on an upper floor.
2 - in free flow, when only a single water tap is to be
supplied. This type of installation is specifically adap-
ted to point-of-use water heaters (i.e. capacities of 10,
15, 30 and 50 L) that cannot be installed as unvented
systems (i.e. pressurised). The installation must be
made with a special mixing tap. In this case there is
no need for a safety valve.
- Bovendien mag het wegvloeiend water bij overdruk
in geen geval worden afgeremd. Dat betekent dat de
aftapbuis constant en op toereikende wijze moet afhel-
len en dat de diameter geschikt moet zijn voor het
debiet.
Tijdens het opwarmen zet het water in de tank uit en
een deel van dat water ontsnapt druppelsgewijze via
de afvoergoot (ongeveer 3 % van de inhoud per ver-
warmingscyclus). U hoeft zich daar geen zorgen over
te maken: dit is een heel normaal verschijnsel.
Wordt het toestel in de hoogte geïnstalleerd, dan is het
raadzaam een vergaarbak met een afvoergoot onder
de boiler te monteren.
2 - met een spontane waterafvoer, voor één enkele
waterkraan. Dit soort installatie is speciaal aangepast
voor de kleine inhoud boilers van 10, 15, 30 en 50
liters, boven en onder de gootsteen volgens de model-
len, toen ze kunnen niet onder druk geplaatst worden.
In dit geval is de installatie van een specifieke meng-
kraan noodzakelijk; een veiligheidselement is echter
overbodig.
9