Orbital Motion; Plunge Cutting - Ryobi P523 Manuel D'utilisation

ORBITAL MOTION

See Figure 7, page 11.
Orbital motion provides faster, more efficient cutting. The
blade cuts through your work in the upstroke but does not
drag across your work in the downstroke.
Orbital Material
Setting Type
Counter Top, Laminate
Board
0
Thin Sheet Metal
Plastics and PVC
1
Scrolling or Curving Cuts
in Wood
Plywood, Decking and
2
Hardwood
General Lumber and
3
Soft Wood
OPTIONAL EDGE GUIDE
(NOT INcLUDED)
See Figure 8, page 11.
An optional edge guide may be purchased separately. It can
be used for making crosscuts and rip cuts.
 Remove the battery pack.
 Insert the edge guide through the two slots in the base
of the saw.
 Adjust to the desired width and lock in place with the
edge guide screw.
 Replace the battery pack.
ScROLL cUTTING
See Figure 9, page 11.
Scroll cuts can be made with the jig saw by guiding the direc-
tion of the cut with applied pressure on the handle as shown.
NOTE: Using blades specifically designed for scroll cutting will
reduce stress on the saw and produce better cutting results.
WARNING:
Excessive side pressure to the blade could result in
broken blades or damage to the material being cut.
Broken blades could result in serious personal injury.
OPERATION
Choose from four orbital adjustment positions for fine to
aggressive cutting. The higher settings should be used when
fast cutting in soft material is desired. The lower settings
should be used when cutting materials with more resistance.
Suggested
Blade Type
Wood Cutting Blade
Metal Cutting Blade
Wood Cutting Blade
Scrolling Wood Blade
Wood Cutting Blade
Wood Cutting Blade

PLUNGE cUTTING

See Figure 10, page 11.
 Mark the line of cut clearly on the workpiece.
 Set the cutting angle at 0°.
 Tilt the saw forward so that it rests on the front edge
 Make sure the blade is inside the area to be cut.
 Using high speed, start the saw and slowly lower the
 Continue lowering the blade into the workpiece until the
 Use only the 7 teeth per inch blade for this type of cut.
7 - English
TPI Speed
(Teeth per inch) Setting
1 0 - 1 2 ( D o w n
Max Speed
Stroke Blade)
Slow - Medium
14-24
Speed
10-12 Medium Speed
10-12 Max Speed
Medium - Max
6-12
Speed
Medium - Max
6-10
Speed
WARNING:
To avoid loss of control, broken blades, or damage to
the material being cut, always use extreme caution when
making plunge cuts. We do not recommend plunge
cutting on materials other than wood.
of the base and blade will not come in contact with the
workpiece when the saw is turned on.
blade into the workpiece until the blade cuts through the
wood.
base rests flat on the work surface, then move the saw
forward to complete the opening.
Orbital
Action
No Orbit
No Orbit
Minimal Orbit
Minimal Orbit
Medium Orbit
Maximum Orbit