Charging Of The Helicopter; Preparation - ACME zoopa 150 Manuel D'utilisation

Charging of the helicopter

Preparation

Place the helicopter on a plain surface, so that the tail rotor points into your direction. Switch
on the helicopter. Check if any obstacles could affect fly. Step back for at least one meter and
then switch on the controller.
First pull the gas stick down, then up and again down – now the helicopter is ready for take
off!
Flying
The range of the controller is about 10m, but can be interfered by sun- or strip lights.
Avoid flying directly under the ceiling or crashing against walls – this causes crashes and can
damage the helicopter. Optimal flight at about 1m height.
Turbo:
By pushing the Turbo button (right on the top of the controller) you can increase the speed.
The flight time is reduced then.
Trimming/Adjust
zoopa
www.acme-online.de
150
The helicopter gets charged by the charging
lead of the controller.
Switch OFF the helicopter and the
controller!
Connect the charging lead under the
coverage at the back side of
with the socket marked "CHA" at the
helicopter. Now switch on the controller.
The procedure is displayed by a red LED
and is finished when the light turns green.
Charging takes about 15 - 20 minutes.
Please note that only full batteries can
charge the helicopter.
If charging is finished earlier, the
batteries in the controller are weak and
have to be replaced! The controller LEDs
starts blinking when too low to charge!
If the helicopter turns around its own shaft,
you can adjust this effect by turning the
trimming wheel.
the controller