Table des Matières
Publicité
Don´t fly if obstacles complicate flying!
Don´t fly if it´s too windy. Close windows and doors!
Charging of the helicopter
You can also charge with an
USB-Cable: Art. No.: AA0121
!!!Never use rechargeable batteries, because these may harm the model. You need 6x AA
Batteries (Art. No.: ACME0036)!!!
Preparation
Place the helicopter on a plain surface, so that the tail rotor points into your direction. Switch
on the helicopter. Check if any obstacles could affect fly. Step back for at least one meter and
then switch on the controller.
Binding the helicopter and controller
The zoopa 150 helicopter features an automatic binding. In case of binding loss, please
proceed as described:
1. Switch on helicopter, the internal red LED starts blinking.
2. Keep pressed the left button on the controller and then switch the controller on. Keep the
button pressed for another 5 seconds. Then release and the controller LED shines green.
3. the internal red helicopter LED shines permanently now.
Both the helicopter and controller are now synchronized and you can start flying.
Flying
www.acme-online.de
ACME the game company
The helicopter gets charged by the charging
lead of the controller.
Switch OFF the helicopter and the
controller!
Connect the charging lead under the
coverage at the back side of the controller
with the socket marked "CHA" at the
helicopter. Now switch on the controller.
The procedure is displayed by the red LED.
The finished charging process is shown as
followed:
-zoopa 150 Force Back 2.4 GHz >orange
LED
-zoopa 150 Greenhorn 2.4 GHz >green LED
-zoopa 150 blu iz 2.4 GHz
-zoopa 150 red heat 2.4GHz
Charging takes about 30-40 minutes.
Please note that only full batteries can
charge the helicopter.
If charging is finalized earlier than
expected, the controller batteries are too
weak and need to be replaced! The
controller LEDs starts blinking when too
low to charge!
>blue LED
>red LED
Publicité
Table des Matières
