Light Function - ACME zoopa 150 Manuel D'utilisation

Helicopter Control

Light function

The light of the helicopter is activated by pushing the upper-left button of the remote control.
Error
The helicopter does not
react
The helicopter turns and
cannot climb
The helicopter does not
gain height
The helicopter does not
react on controller
The range is not sufficient
Please replace defective rotors immediately! – Pay attention on the main rotors label! A
main rotor above and B main rotor below – never place them wrong side out!
zoopa
With the gas stick the altitude of the helicopter
gets controlled – handle the stick very gentle! As
soon as the helicopter has reached an optimal
height (for example 1m), smooth moving of the
stick is sufficient for gaining height. If you pull the
stick down the helicopter looses height.
The right control stick moves the helicopter
forwards and backwards, as well as turning the
vertical axis left and right. If you pull this stick up,
the helicopter moves forward, pulling it down it
moves backwards.
Moving the stick left, the helicopter turns left,
moving it right, the helicopter turns right.
Please note that the direction specifications apply
from pilot´s view – that means if the helicopter
moves away from you, but reverses, it flies ahead
to you!
Troubleshooting
Reason
Batteries not placed in
correctly
Batteries are empty
Move gas stick
Upper rotor unit screws
loosen
Weak battery
Battery not fully charged
Controller batteries too
weak
Controller batteries too
weak
Sun- or neon light disturb
the IR- Signal
www.acme-online.de
150
Check batteries
Replace batteries
First pull it up, then down
and again up
Tight the screws
Charge helicopter
Replace batteries of the
controller
Replace batteries in the
controller
Replace batteries in the
controller
Look for another flight areal
– switch off neon lights
Solution