LGB VT 133 525 Instructions De Service page 12

55015, you can adjust direction and speed for
two seconds after selecting a moving loco
without causing the loco to stop.
CV55 Reset of most programmed CVs
55 = most important CVs are reset to the
factory pre-set values
CV60 Back-EMF: Max. adjustment factor
(0: small, 255: large)
Specifies the max. increase or decrease of
voltage applied during each time interval
(programmed in CV61) Attention! The factory
pre-set values of CV60 and CV61 are optimized
for LGB motors.
CV61 Back-EMF: Adjustment frequency
(0: often, 255: seldom)
Specifies how often per second the motor
voltage is adjusted - accordingly, the loco will
react to curves and grades immediately or with
a short delay
CV62 Back-EMF: Max. Adjustment
(0: small, 255: max.)
Limits the total adjustment in motor voltage.
If there is a very large load on the motor, the
adjustment will not exceed this value - for more
realistic operations, so that locos will slow a bit
on grades.
CV67 Speed steps programmed by user (see CV29):
to 28 speed steps are programmed in CV67 to
CV94.
CV94 With LGB MTS, every second value is skipped
(14 speed steps).
Factory pre-set speed steps:
7, 9, 11, 13, 16, 20, 24, 28, 32, 36, 42, 48, 54,
60, 68, 76, 84, 92, 102, 112, 124, 136, 152,
168, 188, 208, 230, 255
Pre-set values for user-programmable speed steps:
8, 16, 24, 32, 40, 48, 56, 64, 72, 80, 88, 96,
104, 112, 120, 128, 136, 144, 152, 160, 168,
176, 184, 192, 208, 224, 240, 255
Hint: The speed steps are factory pre-set and
programming is not necessary. Use the
55045 MTS PC Decoder Programming Module
for programming.
12
(1..255) [48]
(0..255) [0]
(0..255) [255]
(0..255)