LGB VT 133 525 Instructions De Service page 11

Register Function
CV1 Loco address
CV2 Starting voltage
voltage for speed setting 1 - if loco starts only
at a higher speed setting, increase value. With
"Back-EMF" function active, the factory pre-set
value should not be changed.
CV3 Acceleration (1 = fast, 255 = slow)
CV4 Braking (1 = fast, 255 = slow)
Hint: When programming with the 55015 Universal Remote, the following CVs
are programmed by input of the number of the desired CV in CV6 and then
input of the desired function value in CV5 (see example below).
CV5 Max. voltage
Voltage for highest speed step - if a lower top
speed is desired, decrease value. With
"Back-EMF" function active, the factory pre-set
value should not be changed.
CV5 after input of CV6
function value for CV to be programmed
CV6 CV to be programmed
CV29 Configuration
Normal direction:
4 = Analog and digital, factory-programmed
speed steps
0 = Digital only, factory-programmed speed steps
20 = Analog and digital, user-programmed
speed steps
16 = Digital only, user-programmed speed steps
Reversed direction:
5 = Analog and digital, factory-programmed
speed steps
1 = Digital only, factory-programmed speed steps
21 = Analog and digital, user-programmed
speed steps
17 = Digital only, user-programmed speed steps
With "Analog and digital:"
- Loco can operate on analog and digital layouts
With "Digital Only:"
- Normal operation on digital layouts.
- Operation on analog layouts not possible.
CV52 Command for front light terminal
0 = control via lighting button
1 = control via button 1 (buttons F2-F8 not used)
9 = control via button 1 (buttons F2-F8 used)
10 = control via button 2
11 = control via button 3
12 = control via button 4
13 = control via button 5
14 = control via button 6
15 = control via button 7
16 = control via button 8
64 = control via lighting button
(On only when reversing)
65 = control via button 1
(On only when reversing)
128 = control via lighting button
(On only when moving forward)
129 = control via button 1
(On only when moving forward)
CV53 command for rear light terminal
(see CV52)
CV54 Hand-off function and "Back-EMF"
0 = hand-off function off, Back-EMF off
1 = hand-off function on, Back-EMF off
2 = hand-off function off, Back-EMF on
3 = hand-off function on, Back-EMF on
Hand-off function on: When operating with
Available Factory
values pre-set
(00..22) [3]
(0..255) [0]
(1..255) [3]
(1..255) [3]
(1..255) [255]
[4]
[128]
[64]
(0..3) [2]
11