Using The Alarm To Start Play - Onkyo CR-N775D Mode D'emploi

> Before Start > Part Names

Using the alarm to start play

1
34
> Install > Initial Setup
2
> Playback
Supplementary information | Advanced Setup | Others
Settings
At the set time, the unit switches on and starts play of
the desired source. You can set two different timers,
"Timer 1" and "Timer 2". Make sure that the clock on
this unit is set correctly. You cannot use the timers if the
clock has not been set.
1. Press on the remote controller to display the
menu.
2. Press 3/4 (b) to select "Timer", then press ENTER
(c).
3. Press 3/4 (b) to select "Timer 1" or "Timer 2" and
press ENTER (c).
Timer
Timer 1
Timer 2
Clock
4. Press ENTER (c) when "Timer Set" is displayed.
5. Press 3/4 (b) to select the source to use for timer
play, then press ENTER (c).
0 The sources you can select are "CD", "FM/DAB"
and "MD".
When you select "FM/DAB", press 3/4 (b) to
select a preset station and press ENTER (c). If
there are no stations preset, "FM/DAB" is not
displayed.
To select "MD", you first need to go to the menus
"Option" - "Input Name" to set an input for a jack
to "MD". If "MD" is not set for an input, nothing is
output when the timer starts.
6. Press 3/4 (b) to select "Every" or "Once" and press
ENTER (c).
If you select "Every", select days of the week from
Asb