Front Panel; Part Names - Onkyo CR-N775D Mode D'emploi

> Before Start > Part Names

Front Panel

Part Names

  
  
4
> Install > Initial Setup
  
    
> Playback
1. TIMER indicator: This lights when the alarm is set.
2. Remote control sensor: Receives signals from the remote controller.
0 The signal range of the remote controller is within about 23y/7 m, at an angle of
30° to either side.
3. Display ( P7)

4. Disc tray: Place discs here. 8-cm discs can also be used.
5. < button: Open or close the disc tray.
6. Volume dial: Adjust the volume. Adjust between 0 and 50.
Volume indicator: This lights white when the unit is on.
7. Play buttons:
∫ : Stops playback.
1/; : Plays or pauses playback.
0 Depending on the input, the operation may not start.
8. Í ON/STANDBY button: Turns the unit on or into standby mode.
9. jack: Stereo headphones with a mini plug (Ø1/8z/3.5 mm) are connected.
10.USB port: Connect a USB storage device or HDD (hard disk drive) to play music
files. You can also supply power (maximum 5 V/0.5 A) to USB devices with a USB
cable.
0 When connecting a HDD that requires more than 5 V/0.5 A, connect to the USB
port (maximum 5 V/1 A) on the rear of the unit.
11. DISPLAY button: Switches the information on the display.
0 Depending on the input, the operation may not start.
If the "Bluetooth Wakeup / Clock Call" setting is On, then the current time is
displayed when pressed while in standby mode. (
12.INPUT button: Switches the input to be played. (CD / NETWORK / BLUETOOTH /
USB Front / USB Rear / COAXIAL / OPTICAL / LINE / DAB / FM)
button: When pressed for about 5 seconds, the buttons on the main unit are
locked and unable to be operated. To unlock, press and hold again.
13.MENU button: Displays the menu. (
14.ENTER button, skip (:/9) dial:
When playing, turn left or right to select the folder or file, then press to confirm.
0 Depending on the input, the operation may not start.
While the menu is displayed, turn the dial to select items and press to confirm the
settings.
15.RETURN button: Returns the display to the previous state.
Supplementary information | Advanced Setup | Others
P41)
P39)