Built-In Radio Receiver - Dea 203RR Notice D'emploi Et Avertissements

Operating instructions and warnings
Instructions
The control board is ready to receive instructions
Scroll down the parameters until you visualize procedure P001
Confirm! The control board is ready for the positioning of the gate/door
Position gate/door in its standstill position after opening
Confirm! The control board has memorized the gate/door position
Scroll down the parameters until you visualize procedure P003
Confirm! The control board awaits a further confirmation
Confirm by pressing on the OK key for a few seconds! The procedure starts
Now the gate/door starts to close at a slow speed until it reaches the
stroke end while closing (or the limit switch).
On the display you will read "P003". Motor stroke memorization done!
Scroll down the parameters until "----". The control board awaits further instructions
WARNING If during the door opening you have no access to the push buttons of the control
board, you may configure and memorize the stroke by using the buttons of a 4-channel remote
control stored in memory
Instructions
16
1
By pressing on the
happen, you must swap the two motor cables (input 7 and 9). Only if you use limit switches, first position the gate/door where
you want it to stop in closing and then adjust the closing cam so that it presses on the limit switch associated to it in that point.
Then position the gate/door in the opening position and adjust the opening cam so that it presses on the limit switches asso-
ciated to it in that point.
8.3

Built-in radio receiver

DEA 203RR control board includes a 433,92MHz built-in radio receiver accepting both transmitters with
HCS coding (complete rolling code or just fixed part), and HT12E dip-switch coding.
• The type of coding is selected by programming the working parameter n° 8 "type of coding" (see Table
2 Parameters)
• The receiver memory capacity can contain up to 100 different transmitters.
R
Door/gate positioning
Motor stroke memorization
The control board is ready to receive instructions
Door/gate positioning and Motor stroke memorization
Scroll down the parameters until you visualize procedure
P001
Confirm! The control board is ready for the positioning
of the gate/door
Position gate/door in its standstill position after opening
Confirm! Now the gate/door starts to close at a slow
speed until it reaches the stroke end while closing (or
the limit switch).
On the display you will read "P003". Motor stroke memo-
rization done!
Scroll down the parameters until "----". The control board
awaits further instructions
key the gate/door must open, by pressing on the
Function
1
Function
key the gate/door must close. If this does not
Display
Display
1