Technical Data; Operating Conditions; Assembly And Wiring Instructions - Dea 203RR Notice D'emploi Et Avertissements

Operating instructions and warnings
WARNING DEA System reminds all users that the selection, positioning and installation of all materials
and devices which make up the complete automation system, must comply with the European Directives
98/37/CE (Machinery Directive), 89/336/CE and subsequent amendments (electromagnetic compati-
bility), 73/23/CE and subsequent amendments (low voltage electrical equipment). In order to ensure a
suitable level of safety, besides complying with local regulations, it is advisable to comply also with the
above mentioned Directives in all extra European countries.

5 TECHNICAL DATA

Power supply ....................................................230 V a.c. +/- 10% 50Hz
Flashing light output .........................................230 V a.c. max 40W art. Lumy
Auxiliary power supply output (+24VAUX) ..........24 V a.c. (max 200mA AUX+SIC)
Safety devices power supply output (+24VSIC) ...24 V a.c. (max 200mA AUX+SIC)
Electric lock output ............................................12 V a.c. max 15VA (max 1 electric lock art. 115)
LC/SCA contact capacity ...................................max 5A
Max motor capacity ..........................................2 X 500W max
Fuse F1 ............................................................T5A
Fuse F2 ............................................................T160mA
Radio receiver frequency ...................................433,92 MHz coding rolling code / dipswitch
Max. number of transmitter controlled................100

6 OPERATING CONDITIONS

203RR control board is designed only to control DEA SYSTEM 230 V a.c. gate and door operators,
whose motor is equipped with magnetic encoder, and is therefore suitable for counterweight overhead
doors, sliding doors and barriers. This control board has been designed and tested for operation under
"normal" conditions for both residential and industrial use. The level of protection against dust and water
is illustrated in the instructions booklet of DEA System gate operators equipped with built-in 203RR control
boards.
WARNING Using the product under unusual conditions not foreseen by the manufacturer may cause
dangerous situations; this is the reason why all the conditions prescribed in these instructions must be
followed.
WARNING Under no circumstance must the product be used in an explosive environment or surroun-
dings that may prove corrosive and damage parts of the product.
WARNING To ensure an appropriate level of electrical safety always keep very low tension cables
(motors power supply, controls, electric lock, aerial and auxiliary circuits power supply) apart from (min
4 mm if not insulated, 1 mm through insulation) 230V power supply cables. To keep them apart put
cables inside a tubing tray and fasten them with clamps near the terminal board. Make sure cables are
not damaged or worn off during installation.
WARNING Any installation, maintenance or repair operation on the whole system must be carried out
exclusively by qualified personnel. All these operations must be performed only after disconnecting the
14
power supply, and operating in strict compliance with the electrical standards and regulations in force
in the nation of installation.
WARNING See the user's manual of the operator by DEA System you are working on for further in-
structions on assembling and control board wiring operations (such as drilling holes to allow for wire
passage, cable clamps use, ect). Failure to comply with these instructions may jeopardize the level of
electrical safety.
Connect to the power supply 230 V a.c.± 10% 50 Hz through a multi pole switch or a different device
that can ensure multi pole disconnection from the power supply, with a contact opening of 3 mm. Use a
cable with a minimum section of 3 x 1,5 mm² (e.g. a H07RN-F type).
Make all connections to the terminal board and remember to short-circuit, whenever necessary, all
unused inputs. (See table 1 terminal board connection and Fig. 1 basic and complete wiring diagram)
R

ASSEMBLY AND WIRING INSTRUCTIONS

250V (retarded)
250V (retarded)
A1
A2
A3
A4
A5
A6